Three electric tricycle electric tricycle and pay attention to the battery of standardized operation

three wheel electric tricycle electric tricycle consumers should pay attention to the battery of standardized operation and use of the process, prevent overcharge and over discharge. To take measures to cool the electric tricycle battery after heating, until the temperature of the Electric Tricycle battery before charging back to normal. Electric tricycle battery installation position should be as to ensure good heat dissipation, overheating should be found to stop charging, electric tricycle battery charger and respond checked. Electric tricycle battery discharge depth is shallow or high ambient temperature should shorten the charging time.

Safe use of three electric tricycle battery

three wheel electric tricycle battery discharge to the termination voltage, to continue to discharge as new electric tricycle.
New electric tricycle over discharge. Discharge will seriously damage the battery electric tricycle, three wheel electric tricycle performance and cycle life of the battery is extremely unfavorable. Overall, consumers in the purchase of electric tricycle not only price, mileage and other factors determine the quality of a car, line materials, member contact is good is equally important. And must not have short-circuit the battery, be especially careful when installing or using, tools used insulation measures should be taken, when electrical connection even better than the first battery, the check no short-circuit, and finally even the electric tricycle battery, wiring specification should be well insulated to prevent overlapping compression to rupture, the only way to make electric tricycle safer, more long-term use.

What to buy electric tricycle to pay attention

1, damping: To stand in the electric 3 wheel bikes driving position, up and down hard, the damping effect can be felt appropriate;
2, direction: in his driving position, direction of play to both sides, small torque bad;
3, Battery: This is the most critical, whether it is dry or water batteries, be sure to look at the connection line between the battery pack is not thick enough, I recommended to use water batteries, post-maintenance and low cost.
4, the sheet metal: The overall appearance should be strong, quality welding mouth can be very clearly see the problem
5, the three wheel electric tricycle tires: tire and inner tube to the same model, after so full of gas, tire inner tube wall is thin, easily rolling tires

electric bicycle 3 wheelhow to use and maintain

electric bicycle 3 wheel how to use and maintain: pay attention to read instructions carefully to understand the function of Electric Tricycles, with particular attention to the matter. First, pay attention to clean, especially in winter after saline water should be promptly cleaned, otherwise easily cause corrosion of metal parts, paint aging off. Handlebars and seat are adjustable, when it is necessary to adjust ride comfort, the second is to pay attention to the maximum adjustment height. Handlebar risers and saddle tube should be engraved with the safety line from the lower end of the saddle tube is generally 2.5 times the diameter, which is the maximum adjustment height, when adjusting the safety line can not be exposed. After the new Juji period of time, to deal with the whole car electric tricycles check adjustment. Then tightening and lubrication is essential. Check each fastener should be loose, transmission parts should be flexible, pay attention to after the chain lubrication oil slick wipe a little oil to the flywheel point. Tires inflated to the proper, otherwise it will affect riding comfort and service life. Brakes are the basic guarantee of security, but should always check, as long as there are problems to be adjusted or repaired immediately.

Battery car battery electric Why not start

Not start Cause:
Turn the controller line, the motor can not be a bad start, there needs to detect a fault, battery feed, also can not start off the grid.
1; three wheel electric tricycle brake lights normal, indicating that the brakes is not broke, do not consider the power brakes.
2, for turn to, because there are only a small rotation of the magnet and a Hall sensor children.
3, if then turn to the two thread even what can go there, basically your controller is good.
Final judgment is electric bicycle 3 wheel turn to the middle line there is a bad phenomenon -------- from the handle to the controller that a thick black line that [there are three fine line] inside the thin red line or thin green line has a problem, fine black all right, because the fine black if not in contact coaster.

The selection of three electric bicycle

  1, the Electric Tricycle various parts of the switch is sensitive and reliable. 2, steady speed, and reliability. Slowly turn the handle speed, the motor should be a smooth start, acceleration, after releasing the handle, the handle can be quickly reset, the motor evenly decelerates. 3, electric bicycle 3 wheelbrake power quickly and reliably. Rotational speed control handle, after the motor is running, after pinching brake brake, the motor can instantly power, if power display, you can see the display back to zero. 4, the battery easy disassembly. Lead-acid batteries usually weighs about 13.5kg, due to the dismantling day, so the battery location must be suited to their body.

Should choose electric bikes note the following:

1, the Electric Bikes the fastening screw nut should be tightened, not loose and fall off. 2, each rotating parts should be flexible operation, it may not have stuck, stay stiff phenomenon. Such as: front and rear wheels should rotate flexible, and should not swing around and up and down, it will be stopped when the front and rear wheels should do a brisk swing, not suddenly stop turning. Turning left and right should be flexible and comfortable handlebar, pedal axle and the crank should be tightened, not loose each other, and flexible rotation. 3, shift the car in the correct speed range strain gear, shift position should be clear, there can not be neutral in the middle. 4, the chain should be suitable elastic, flexible operation. Forward Reverse repeatedly shake hands crank sprockets, chains flexible operation, not a jump chain and shedding phenomenon. 5, with both hands above the front and rear part of the saddle, one hand firmly under the front of the presser saddle, saddle front-end can not be staying. Then hands horizontal turning of the saddle, the saddle should not be rotated. 6, the selection of brakes and brake system: hands holding the handlebars, while the front and rear brakes were about push bike, then the wheel should not rotate; release the handle, the brake system should be able to quickly reset. 7, each electric bicycle bike parts surface should be clean, no stains, rust, trademark decals should be complete, clear, no sharp edges burrs, etc., such as fender and chain guard edge should not have prickly feeling brakes and other end of the rope should be installed protective covers. 8, grade or label observe parts. Generally good parts are marked with significant trademark mark and clear and beautiful patterns, while lemons are rarely marked or rough.